Unilever Pureit Classic Mineral RO+MF
Pureit brings to you the Pureit Classic RO+MF^ with its superior RO purification technology that reduces the maintenance cost and at the same time increases the filter life by 2 times* as compared to ordinary water purifiers.
Lowest Maintenance Cost*
Think a water purifier always comes with a high maintenance cost? Think again. Pureit introduces the new classic RO+MF^, which reduces the maintenance cost per liter is 2 taka
Double Filter Life
Gone are the days of changing the filter of your water purifier time and again. The Pureit Classic RO+MF^ has a long filter life of 3000 litres.
High Water Saving*
With water shortage being an ever-increasing problem, who doesn’t want to save water? The Pureit Classic RO+MF^ saves water up to 35% whereas ordinary RO saves water only up to 25%
- Storage Capacity: 6 Liters
- Flow Rate: 10-12 Liters
- TDS Reduction; 90%/min
- 6 Stage purifying Technology
- Pump Type: Diaphragm pump 24V DC
- Power Rating: 60 watts
- Operating Voltage: 165-240 Va.c 50 Hz
- Length of Power Adapter: 1.5 Meters
- Total Dissolved Solids: Up to 1800 mg/liter
- Total Hardness: 500 mg/liter (max)
- Iron in Input water: 0.3 mg/liter (max)
- Turbidity of input: 1 NTU (max)
*Under test condition, Input TDS-750 ppm, Turbidity-<1 NTU, Input Pressure-10 psi. Input Hardness-300 ppm, Temp.-room temp. When compared with annual maintenance contracts of branded ROs. Applicable for a family consuming 6000 litres in 1 year.
**Permeate flow rate and recovery are based on standard test conditions and may vary depending on input water quality, TDS, pressure and life of Filter elements
***Input water quality and TDS content are important determinants of output water quality.
****If input pressure exceeds 30 PSI, please install a company provided pressure reducing valve at an additional cost. If the pressure is lesser than 10 PSI then you need to buy ‘Pressure enhancing pump at an additional cost. Device should not be installed in a house where input pressure is greater than 60 psi.
#Technical specifications are subject to change or improvement without prior notice
##In case the TDS is > 1000 ppm, a company provided anti-scalant is recommended to be installed, this has to be purchased at extra cost.
###If the iron content in the input water is more, it is recommended to install a company provided iron filter.